AR3602 Syllabus - Structural Design Of Steel - 2021 Regulation Anna University

AR3602 Syllabus - Structural Design Of Steel - 2021 Regulation Anna University

AR3602	STRUCTURAL DESIGN OF STEEL	L T P/S C

3003

OBJECTIVES:

• To introduce basic structural members in steel.
• To enable an understanding of the types, efficiency and strength, advantages and disadvantages of bolted and welded joints.
• To enable the design of tension members, beams and columns under different conditions.

UNIT I	INTRODUCTION TO STRUCTURAL STEEL	6

Introduction to properties of steel, Standard sections, advantages and disadvantages of steel as construction material.

UNIT II	BOLTED AND WELDED JOINTS	10

Assumptions. Types of Joints and Failure–Advantages and Disadvantages. Design of joints for axially loaded members using limit state method. (excluding eccentric connections).

UNIT III	TENSION MEMBERS	10

Introduction. Net sectional area. Permissible stresses. Design of axially loaded tension member using limit state method. Lug angle. Tension splice.

UNIT IV	COMPRESSION MEMBERS	10

Introduction. Different sections. Built up section. Design of columns using limit state method (excluding lacing, battening).

UNIT V	FLEXURAL MEMBERS	9

Introduction. Laterally supported and unsupported beams. Design of laterally supported beams using limit state method.

TOTAL: 45 PERIODS

OUTCOMES:: Upon completion of the course, students will be able to

 Ability to design steel joints for maximum efficiency and strength.  Ability to design tension and compression members for different conditions by applying the code provisions.  Ability to design different types of laterally unsupported and supported steel beams for different conditions.

TEXT BOOKS:

1. S.K. Duggal, 'Limit State Design of Steel Structures', McGraw Hill Education, Private Limited,2017. 2. N. Subramanian, 'Design of Steel Structures', Oxford, 2015.

REFERENCES:

1. M.R. Shiyekar, 'Limit State Design in Structural Steel', PHI Learning Private Limited, 2013. 2. Dr. V. L. Shah and Prof.Veena Gore, 'Limit State Design of Steel Structures', Structures Publications, Pune, 2012. 3. S.S. Bhavikatti, 'Design of Steel Structures by Limit State Method as per IS800-2007', I.K.International Publishing House Pvt, Ltd, 2012. 4. IS 800 - 2007 – Code of Practice for use of Structural Steel in General Building Construction. 5. SP 6 IS Handbook for Structural Engineers.